Quick Link
Quick Contact
Address
6 building,No 98, Fulian 1 road,Baoshan district, Shanghai, China.
Tel
86-021-80392549
Our Newsletter
Subscribe to our newsletter for discounts and more.
| Parameter | RH56H1-E2-TI Series (Tactile, EtherCAT + RS485) |
RH56H1-E4-TI Series (Tactile, EtherCAT + CAN FD) |
Unit |
|---|---|---|---|
| Tactile Channels | 8 | 8 | channels |
| Tactile Range | 30 | 30 | N |
| Tactile Accuracy | 5 | 5 | % FS |
| Force Resolution | 0.1 | 0.1 | N |
| Degrees of Freedom | 6 | 6 | DOF |
| Number of Joints | 12 | 12 | pcs |
| Weight (Right / Left) | 630 ± 10 / 620 ± 10 | 630 ± 10 / 620 ± 10 | g |
| Thumb Fingertip Strength | ≥ 15 | ≥ 15 | N |
| Fingertip Strength | ≥ 20 | ≥ 20 | N |
| Hand Closing Time | < 0.8 | < 0.8 | s |
| Repeatability | ± 0.2 | ± 0.2 | mm |
| Thumb Lateral Rotation | 60 – 180 | 60 – 180 | ° |
| Thumb Flexion Speed | > 37 | > 37 | °/s |
| Four-Finger Flexion Speed | > 107 | > 107 | °/s |
| Operating Voltage | 24 – 48 | 24 – 48 | V DC |
| Peak Current | 5 @ 24 V | 5 @ 24 V | A |
| Quiescent Current | 194 ± 10 mA (RS485) / 101 ± 10 mA (EtherCAT) | 193 ± 10 mA (CAN FD) / 206 ± 10 mA (EtherCAT) | mA |
| Sensing Channels Total | 24 | 24 | pcs |
Q1: How is the tactile version different from the base RH56H1?
The tactile suffix adds eight calibrated pressure channels on the palm and finger pads. The base version reports joint torque, position and temperature but gives no direct contact pressure reading.
Q2: Can tactile data be read together with joint commands on one bus?
Yes. Tactile values are published in the same EtherCAT object dictionary and the same RS485 or CAN FD frames that carry joint commands, so no second cable or gateway is needed.
Q3: How often does the skin need recalibration?
Calibration data is stored on board and normally holds for the service life of the hand. Recalibration is advised only after pad replacement or after a recorded overload above the 30 N range.
Q4: Is the hand delivered as a matched right and left pair?
Single hands and mirrored pairs are both available. The right hand weighs 630 g plus or minus 10 g and the left hand 620 g plus or minus 10 g.
Q5: What does the controller need to run the force loop?
Any master that supports EtherCAT at 1 kHz, or RS485 and CAN FD at the documented frame rate. Sample control code and the register map are provided with the shipment.