Quick Link
Quick Contact
Address
6 building,No 98, Fulian 1 road,Baoshan district, Shanghai, China.
Tel
86-021-80392549
Our Newsletter
Subscribe to our newsletter for discounts and more.
The CTPM2F40 is a servo driven electric parallel gripper built for firm handling of heavier workpieces on CNC tending and assembly lines. Instead of a fixed air cylinder, its integrated servo drive closes the two fingers with programmable position, speed and force, so a 40 mm stroke is used with intent rather than by habit: the 100 N grip force and 1.5 kg recommended payload put it in a different class from a light assembly gripper, so a machined blank, a filled carton or a metal bracket can be held firmly through a fast robot move instead of slipping in the jaws. The body weighs only 1.3 kg and repeats to ±0.02 mm, which is what keeps the jaw position stays where it was commanded, cycle after cycle, on parts that are heavy enough to punish a weak hold.
- 100 N grip force: enough holding force for metal blanks, filled cartons and heavy assemblies, and fully programmable so the same gripper can handle a rigid casting and a softer part.
- Higher payload ceiling: a 1.5 kg recommended load, combined with rated moments of MR 15.8 Nm, MP 9.6 Nm and MY 9.6 Nm, supports long or offset custom fingers without losing accuracy.
- Wide 40 mm stroke: covers a broad range of part sizes, so mixed-SKU lines need fewer gripper changeovers.
- Rigid servo positioning: ±0.02 mm repeatability means the part is placed where the program says, which matters when a gripper feeds a fixture or a machine spindle.
- Drop-proof self-locking fingers: if power is interrupted mid-transfer, the part stays clamped instead of falling onto the machine or the floor.
- Low maintenance design: integrated drive and control with no air preparation, no valves and no tubing, so there is less to leak, adjust or replace.
- Drive and control combined: 24 V power plus Modbus RTU (RS485) or discrete IO is all the wiring needed, which shortens commissioning on existing cells.
- Fieldbus ready: CAN, TCP-IP, EtherCAT and Profinet can be added on request to match an existing network standard.
- Fits industrial arms and cobots: the flange pattern and 1.3 kg body suit small and mid-size 6-axis robots, and the gripper reports its state so the robot program can branch on a real signal.
- Feedback for quality control: position, part size, speed and force are readable, so a machine tending cell can confirm the blank is seated before the cycle starts.
Q: Will 100 N damage softer parts?
A: Grip force is programmable, so the 100 N maximum is a ceiling rather than a fixed value. Thin-walled or coated parts can be gripped at a lower setpoint while heavy blanks use the full force.
Q: Can it hold a part if air or power fails?
A: Yes. The fingers are self-locking, so a clamped part stays clamped when power is removed, which protects both the part and the machine during an unexpected stop.
Q: What is included with the gripper?
A: The gripper body with integrated servo drive, the standard flange mounting pattern and the connector for power and communication. Custom fingers and fieldbus options are quoted separately.