Quick Link
Quick Contact
Address
6 building,No 98, Fulian 1 road,Baoshan district, Shanghai, China.
Tel
86-021-80392549
Our Newsletter
Subscribe to our newsletter for discounts and more.
The CTPM2F30 is a servo driven electric parallel gripper built for fast pick and place on packaging and small part handling lines. Instead of a fixed air cylinder, its integrated servo drive closes the two fingers with programmable position, speed and force, so a 30 mm stroke is used with intent rather than by habit: the 30 mm stroke covers a wider spread of part sizes than a micro gripper, and the 85 mm/s closing speed is what lets it keep up with a fast indexing conveyor instead of becoming the bottleneck. The body weighs only 1.2 kg and repeats to ±0.02 mm, which is what keeps the cycle stays repeatable even when the line runs non-stop across three shifts.
- High closing speed: 85 mm/s jaw speed shortens every open-close cycle, which directly raises picks per minute on a fast conveyor without adding a second gripper.
- Wider working window: a 30 mm stroke takes parts from small cartons and bags up to mid-size components, so one gripper family covers several SKUs instead of one gripper per product.
- Programmable grip force: 35 N can be dialled down for thin-walled parts or up for a firm hold on a heavier insert, all from the controller and without swapping fingers.
- Rigid finger guidance: the rated wrist moments of MR 11.8 Nm, MP 7.4 Nm and MY 7.4 Nm allow offset fingers and custom jaws without the deflection that ruins placement accuracy.
- Compact servo body: 1.2 kg and a small footprint keep the gripper out of the way of fixtures, and the drop-proof self-locking fingers keep the part safe when the cell is stopped mid-cycle.
- Integrated drive and control: one power cable plus Modbus RTU (RS485) or IO is enough, so commissioning takes minutes rather than a pneumatic valve-and-tubing build.
- Optional fieldbus: CAN, TCP-IP, EtherCAT and Profinet are available on request for lines that already standardise on a fieldbus.
- Mounting flexibility: the flange pattern suits small industrial arms, cobots and gantry units, and the lightweight body preserves payload capacity for the part itself.
- Readable feedback: position, part size, speed and force can be fed back to the PLC, so the line can reject a bad pick instead of jamming further downstream.
Q: How fast can it cycle?
A: The jaw closes at up to 85 mm/s and stroke and speed are programmable, so cycle time is tuned to the conveyor rather than fixed by air pressure. Actual picks per minute depend on the approach move of your robot.
Q: Can I use custom fingers?
A: Yes. The rated moments of MR 11.8 Nm, MP 7.4 Nm and MY 7.4 Nm leave room for offset or shaped jaws. Send your finger drawing and we will confirm the load case.
Q: What is the recommended payload?
A: Up to 0.7 kg including the fingers. Staying inside that limit keeps repeatability at ±0.02 mm over long production runs.