Quick Link
Quick Contact
Address
6 building,No 98, Fulian 1 road,Baoshan district, Shanghai, China.
Tel
86-021-80392549
Our Newsletter
Subscribe to our newsletter for discounts and more.
The CTPM2F14 is a servo driven electric parallel gripper built for micro part pick and place inside compact assembly stations. Instead of a fixed air cylinder, its integrated servo drive closes the two fingers with programmable position, speed and force, so a 14 mm stroke is used with intent rather than by habit: grippers of this size usually force a compromise between stroke and body thickness, and the CTPM2F14 answers it with a slim servo module, so it can sit between two fixtures without touching either of them. The body weighs only 0.55 kg and repeats to ±0.02 mm, which is what keeps a small part cell running through thousands of cycles a day without drift, re-teach or finger re-shimming.
- Slim body for tight cells: 0.55 kg and a low profile let the gripper reach into assembly nests, jigs and inspection slots where a standard parallel gripper will not fit.
- Programmable force for fragile parts: grip force, closing speed and stroke are set from the controller, so one gripper handles both a delicate connector shell and a stiffer metal insert without changing fingers.
- Consistent position control: servo feedback means the jaw opening is a commanded value, not a mechanical guess, which shortens changeover and keeps part seating repeatable.
- Drop-proof self-locking: the fingers hold their position if power is cut, so a part in mid-transfer is not dropped when a cell is paused or e-stopped.
- Low maintenance duty cycle: no air lines, no valve bank and no lubrication schedule, which removes the most common cause of gripper downtime in small part cells.
- Drive and control in one housing: power and Modbus RTU (RS485) or discrete IO are the only connections needed, so a single cable replaces the valve, tubing and sensor stack of a pneumatic gripper.
- Fieldbus options: CAN, TCP-IP, EtherCAT or Profinet can be added on request for cells already running a fieldbus network.
- Robot and cobot friendly: the mounting pattern and 24 V supply suit small 6-axis arms, SCARA units and cobots, and the light weight keeps payload margin intact.
- Feedback to the cell controller: position, part size, speed and force can be read back, which allows the line to detect a missed or wrongly seated part instead of scraping it downstream.
Q: Can this gripper be used on a collaborative robot?
A: Yes. It runs on 24 V, weighs 0.55 kg and clamps with programmable force in the 24 N range, which fits typical cobot payload and safety limits. Cable routing and force limits should be set for the specific cobot model.
Q: What do I need to control it?
A: Modbus RTU over RS485 or discrete IO will run the gripper on its own. If your cell already uses CAN, TCP-IP, EtherCAT or Profinet, those can be provided as an extension.
Q: Which parts is it suited to?
A: Small, light components: connectors, plastic housings, small machined parts, glass or electronic sub-assemblies in the 0.5 kg class, wherever a 14 mm stroke is enough to clear the part.