Quick Link
Quick Contact
Address
6 building,No 98, Fulian 1 road,Baoshan district, Shanghai, China.
Tel
86-021-80392549
Our Newsletter
Subscribe to our newsletter for discounts and more.
Press-fit assembly is unforgiving work. A connector has to enter square, at the right depth, with force applied slowly enough that the housing does not tilt and the pins do not splay. Push too fast and the board flexes; approach at an angle and a pin folds over - and the failure is only discovered at electrical test. On an electronics line running high-mix, short-takt production, operators cannot hold that discipline for a full shift, which is exactly where scrap comes from. This compact arm brings the discipline instead: the wrist stays rigid under insertion load, positioning repeats closely enough that the connector seats on the first approach, and the small body fits between test stations where a full-size robot has no room to stand.
- Square insertion every cycle: a rigid wrist resists tilting under press-fit load, so connectors enter straight and pins stay intact.
- Consistent insertion depth: repeatable positioning delivers the same travel every time, protecting housings and PCB standoffs.
- Short, quick approach moves: fast axis speeds keep press-fit cycles inside the line takt.
- Fits dense 3C cells: a compact base and slim arm work between test handlers, tray feeders and conveyors.
- Gentle handling of light parts: a low-mass arm accelerates and settles cleanly, which matters for small, delicate modules.
- Sealed construction: full IP67 protection (IP69K optional) handles cleaning and dust in electronics workshops.
- Force control ready: FANUC force sensing options allow controlled press-fit insertion, with force and travel limits that stop the cycle instead of crushing a part.
- Vision ready: iRVision options locate connectors and PCB features so insertion follows the actual part, not a nominal position.
- Open fieldbus options: EtherCAT, DeviceNet and PROFINET connect the robot to press controllers, line PLCs and MES terminals.
- Upper-arm services: integrated signal and air lines on the upper arm reduce cable dress for grippers and sensors.
- Compact controller: a Mate-class cabinet fits into crowded line-side electrical rooms.
- Common programming platform: integrators already running FANUC cells reuse the same teach pendant workflow and safety routines.
- Spares commonality: shared FANUC parts and a global service network keep mean time to repair short.